Publicidad
Idiomas disponibles
Idiomas disponibles
EN
5.4
OPERATE ON SLOPES
Do not mow on slopes with incline more than 15°. If you
are not comfortable, do not mow on a slope.
•
Do not go up and down on a slope, mow across the face
of the slope. Be careful when you change the direction on
a slope.
•
Monitor holes, roots, rocks, and other hidden objects that
can cause you to fall. Remove all obstacles such as rocks
and tree limbs.
•
Make sure that your footing is stable. If you are out of
balance, release the handle switch immediately.
•
Do not mow near drop-offs, ditches, or embankments.
5.5
OPERATION TIPS
•
Do not try to override the operation of the start button or
handle switch.
•
Do not tilt the machine when you start it.
•
Do not put hands or feet near or below the turning parts.
•
Keep the discharge chute clean.
•
Do not cut wet grass.
•
Higher blade height is necessary for new or thick grass.
•
Clean the bottom of the mower deck after each use.
Remove grass clippings, leaves, dirt, and other debris.
6
MAINTENANCE
Remove the safety key and battery pack from the machine
before maintenance.
Keep the engine and battery pack free from grass, leaves or
too much grease.
Use only approved replacement parts.
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
WARNING
WARNING
WARNING
CAUTION
CAUTION
CAUTION
English
6.1
GENERAL MAINTENANCE
•
Before each use, examine the machine for damaged,
missing, or loose parts such as screws, nuts, bolts and
caps.
•
Tighten correctly all the fasteners and caps.
•
Clean the machine with a dry cloth. Do not use water.
6.2
REPLACE THE BLADE
Figure 10
Use only approved replacement blades.
Wear heavy gloves or wind cloth around the blade when
you touch the blade.
1. Stop the machine.
2. Make sure that the blade fully stops.
3. Remove the safety key and battery pack.
4. Turn the machine to its side.
5. Wedge a piece of wood between the blade and mower
deck to prevent the movement of the blade.
6. Untighten the mounting bolt and remove the spacers.
7. Remove the blade and replace with a new one.
8. When fitting the blade, make sure it is installed in the
right direction as shown in the figure. The raised points
on the positioner must be aligned with the holes in the
blade.
9. Retighten the mounting bolt. Recommended tightening
torque should be approx. 33-37 Nm.
6.3
STORE THE MACHINE
•
Remove the safety key.
•
Remove the battery pack(s).
•
Clean the machine before storage.
•
Make sure the motor is not hot when you store the
machine.
•
Make sure that the machine does not have loose or
damaged parts. If it is necessary, follow these
instructions:
•
Replace the damaged parts.
•
Tighten the bolts.
•
Speak to a person at an approved service center.
•
Store the machine in a dry area.
•
Make sure that children cannot come near the machine.
6
WARNING
WARNING
Publicidad
