Publicidad
Idiomas disponibles
Idiomas disponibles
USER MANUAL
GB
Com Uni 3 Universal remote control
Congratulations on purchasing this high performance Com Uni 3 remote control. Great
care has been taken of the design and manufacture of this product and in normal use
it will give many years of satisfying service. The following pages describe how to get
the best from your new remote control, but if in doubt please contact your retailer.
About your Com Uni 3 remote control
With your new Com Uni 3 remote control you can not only control all functions of your
STB or SAT receiver, but also the core functions of your TV set.
How does the Com Uni 3 remote control work?
By pressing any button on the remote control a command ist been sent to the device
being controlled, using an infrared beam. At the front of this command is a 3-digit
code, which is unique to that particular unit. This means that when you point a
controller at the TV, for example, the VCR will not respond!
The set-up of your remote control requires the programming of this unique 3-digit-
code.
The 10-second rule
The Com Uni 3 remote control initially needs your assistance to work properly.
All programming is based on the 10-second rule: every step in these instructions must
be completed within 10 seconds after the previous step. Otherwise, the remote control
returns to standard operating mode. This rule ensures that your Com Uni 3 remote
control is not reprogrammed by another user by accident.
Inserting and changing the batteries
Your Com Uni 3 remote control is powered by two alkaline 1.5 V batteries (IEC LR 03,
AAA). Wherever possible, ensure that new batteries are used.
Never mix old and new batteries together as this will effect the performance of the
remote control and shorten the battery life.
Please note:
Insert the batteries following the markings inside the battery compartment.
Immediately dispose of any leaking batteries.
Dispose old batteries as per manufacturer's instruction.
Testing Com Uni 3 remote control the for operation
Once the batteries have been inserted, press any button to ensure that the green LED
response from the remote control please check the battery insertion or the condition
of the batteries. If during operation the operating range diminishes the batteries may
need to be replaced. Your Com Uni 3 remote control has an inbuilt special feature
which allows you to change batteries without losing pre-programmed information. After
replacing the batteries all programmed functions will continue working as before.
4
USER MANUAL
GB
Com Uni 3 Universal remote control
A. Key assignment
The Com Uni 3 remote control has three operating modes, the STB mode, SAT mode
and TV mode. Pressing the keys "STB", "SAT" or "TV" select the particular mode. A
LED shows the activated mode (green for STB, red for SAT and orange for TV). All
modes STB, TV and SAT are pre-programmed by factory settings.
STB and SAT mode
The STB and SAT mode contain following functions:
•
Power / Standby
•
Numbers 0 to 9
•
Channel +/–
•
Volume +/–
•
FLOF colours (red, green, yellow and blue)
•
Teletext on/off
•
Mute
•
Info
•
EPG
•
List
•
Back
•
Menu
•
Exit
•
OK
•
Cursor
•
TV/Radio
•
Recall
•
FAV
•
LANG
•
SUB-T
•
Pause
•
Audio
TV mode
The TV mode contains following functions:
•
Power / Standby
•
Numbers 0 to 9
•
AV
•
-/- -
•
Channel +/–
•
Volume +/–
•
OK
•
Cursor
•
FLOF colours (red, green, yellow and blue)
•
Teletext on
•
Teletext off
•
Mute
•
16:9
•
Info
5
Publicidad
