Publicidad
Idiomas disponibles
Idiomas disponibles
USER MANUAL
GB
Com Uni 3 Universal remote control
E. Identifying the 3 digit code
To identify the currently programmed 3 digit code, please follow the steps below.
succession. (after approx. 3 seconds).
"2" for the second digit and "3" for the third digit. After each digit key has been
Please note:
respective code digit is 0.
Example:
3-digit code is thus 3.
is thus 1.
code is thus 6.
In this example, the code is thus 316.
We recommend that you write down the codes for your devices in the respective
Com Uni 3 remote control. The programmed codes retain in the memory even in case
of a battery change.
To identify the code for the STB and SAT mode please proceed as described above for
television sets, but instead of "TV" key use the "STB" or "SAT" key.
Write down the 3-digit codes here:
STB
SAT
TV
F.
Reset
This functionality resets all settings to the factory settings.
the code 0 0 0
Com Uni 3 remote control is reset to the factory settings.
To reset the STB and SAT mode please proceed as described for resetting the TV
mode, but instead of "TV" key use the "STB" or "SAT" key.
0 0 2, the green
8
USER MANUAL
GB
Com Uni 3 Universal remote control
G. Additional functions
Key and mode lock
After a successful programming (STB, SAT or TV mode) certain keys can be locked.
(Protection against faulty operation)
succession. (after approx. 3 seconds).
Please note: you have the possibility to lock the complete mode by pressing the mode
selection key (STB, SAT or TV).
4. After deactivating the last desired key press "TV" in order to complete the
procedure.
If no button is pressed within 10 seconds after the previous step, the remote control
To apply the single key lock for the STB and SAT mode please proceed as described
for the TV mode, but instead of "TV" key use the "STB" or "SAT" key.
Only the function „Reset" (Code 0 0 0) cancels the single key lock.
Please note: After a reset, the code needs to be programmed again.
Following keys are excluded from the single key lock procedure:
•
Standby
• Numbers 0 to 9
•
Cursor
• P+ / P–
•
V+ / V–
• Mode keys (STB / SAT / TV)
Code lock
After a successful programming (STB, SAT or TV mode) each mode can be protected,
so that your remote control is not reprogrammed by another user by accident.
succession (after approx. 3 seconds).
Now the TV mode is protected against reprogramming by accident.
To remove the code lock follow the same procedure (unlocking).
succession (after approx. 3 seconds).
Now the TV mode can be programmed.
To apply the code lock for the STB and SAT mode please proceed as described for the
TV mode, but instead of "TV" key use the "STB" or "SAT" key.
Volume function#
In the SAT and STB mode you have also the possibility to control the volume of the
TV-set.
To deactivate this function enter the code 0 0 5.
0 9 9, the green
0 8 8, the green
0 8 8, the green
0 0 4, the LED
9
Publicidad
