Publicidad
• WARNING when set on hot
water supply: Danger of scalding!
• The faucet has an adjustable
hot limit ring.
• Make sure that no caustic or
corrosive agents, such as
cleaning agents or household
detergents get in contact with
the connection hoses, as this
can cause water damage.
• There could be sharp edges,
even with careful production.
Please be careful.
TECHNICAL DATA
• Flow pressure: Recommended
as 1.5 to 6 bar; in case of more
than 6 bar connection pressure,
we recommend that a pressure
reducer is installed.
• Water temperature: max. 60 °C.
INSTRUCTIONS FOR CARE
Sanitary faucets require special
care. Therefore please pay atten-
tion to the following instructions:
• Chrome-plated surfaces are sen-
sitive to agents used to dissolve
limescale, acidic cleaning agents
and all types of abrasive cleaners.
• Coloured surfaces must never be
cleaned with abrasive, caustic or
alcohol-based agents.
• Clean your faucets with clear
water only, using a soft cloth or
chamois.
• Please make sure that the clean-
ers do not enter the cartridge
housing. This can lead to a stiff
operating lever and noises.
Do not forget to unscrew the
mixer jet at regular intervals and
remove any limescale residue or
foreign bodies. It is recommended
to replace the mixer jet with a new
one if it is very dirty.
MAINTENANCE
• Please note that a cartridge is
a wear part. If the water is very
hard or dirty, you may need to
replace it every 1-2 years
(see page 15).
• Check all connections at regular
intervals for leakage or visible
damage.
• In the event of leakage or visible
damage to the faucet or con-
nection hoses, these should be
checked or replaced immediately
by an expert.
• You can purchase a new car-
tridge from the service centre
indicated.
REPLACING THE
MIXER NOZZLES
• Undo the mixer nozzle housing
using a mixer nozzle wrench.
• Remove the mixer nozzle
insert .
• Remove the gasket .
• Replace the mixer nozzle .
• Subsequently put the individual
parts together again.
13
Publicidad
