Battery Installation; Low Battery Warning - Textron Greenlee Communications Tele-Mate Pro TM-700 Manual De Instrucciones

Terminal de pruebas
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Setup

Battery Installation

Electric shock hazard:
Before opening the case, remove the test leads from the circuit and shut off the unit.
Failure to observe this warning could result in severe injury or death.
The TM-700 requires two AA batteries to be installed for all functions to operate. Greenlee recommends
alkaline batteries, which are more leak resistant and offer much longer operating life than standard
zinc-carbon types.
When a battery is first installed, the unit will default to a Language Setup display (Figure 1). Select a
language before using the unit.
To access the battery compartment, loosen the screw located at the top of the unit and slide the
battery cover out. Insert the new alkaline batteries, carefully checking that the polarity is correct before
replacing the cover and re-tightening the screw. (Do not overtighten the screw.)

Low Battery Warning

When the battery voltage becomes low, a warning sound is produced each time the mode switch
position changes. In addition, a small battery icon
If the battery voltage is allowed to drop below a critical level, the unit will remind you to replace the
battery for a few seconds and then return to standby mode.
Reset
The TM-700 should start operating normally following battery insertion or replacement. If the unit fails
to respond normally at any time, perform a manual reset by holding
10 seconds. The unit should then start as normal, provided the battery voltage is ok.
6
is displayed in the lower left of the screen.
(power) down for more than

Publicidad

Tabla de contenido
loading

Tabla de contenido