Sauder Cannery Bridge Serie Instrucciones De Montaje página 26

Step 20
å
Fasten two SHORT EXTENSION RAILS (1) to the RIGHT END (B). Use six 3/8" FLAT HEAD SCREWS (22).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other holes that lines up with the holes in the RIGHT END. Turn a
SCREW into these holes.
3/8" FLAT HEAD SCREW
(6 used in this step)
Page 26
22
B
www.sauder.com/service
1
1
Open end
429556