Publicidad
Idiomas disponibles
Idiomas disponibles
Adjustments and Settings
Power Control
Power Control provides convenient functions for saving power.
Energy Save
You may use one of the three Energy Save modes to save power
consumption.
1
Press HOME MENU.
2
Select "Power Control". ( /
3
Select "Energy Save". ( /
4
Select "Save1", "Save2", or "Picture Off". ( /
ENTER)
Item
Description
Standard
Maximum picture brightness; may increase glass
panel buzzing.
Save1
Slightly reduced power consumption and brightness;
optimal setting for most uses.
Save2
Lowest power consumption; slightly decreased
brightness.
Picture Off
Deactivates the screen to save power. To restore the
screen display, press any button other than VOL +/–
and MUTING.
This setting is not memorized by the system.
5
Press HOME MENU to exit the menu.
NOTE
• You can also select this function using the Home menu
when the input source is a PC.
No Signal off (AV mode only)
The system will be automatically placed into the standby mode
if no signal is received for 15 minutes.
1
Press HOME MENU.
2
Select "Power Control". ( /
3
Select "No Signal off". ( /
4
then ENTER)
Select "Enable". ( /
Item
Description
Disable
Does not place the system into the standby mode.
(factory default)
Enable
Places the system into the standby mode if no signal
is received for 15 minutes.
5
Press HOME MENU to exit the menu.
NOTE
• Five minutes before the system is placed into the standby
mode, a message appears every minute.
• The system may not be placed into the standby mode when
noise signals are present at the Plasma Display System after
a TV program finishes.
then ENTER)
then ENTER)
then
then ENTER)
then ENTER)
No Operation off (AV mode only)
The system will be automatically placed into the standby mode
when no operation is performed for three hours.
1
Press HOME MENU.
2
Select "Power Control". ( /
3
Select "No Operation off". ( /
4
then ENTER)
Select "Enable". ( /
Item
Description
Disable
Does not place the system into the standby mode.
(factory default)
Enable
Places the system into the standby mode if no
operation is performed for three hours.
5
Press HOME MENU to exit the menu.
NOTE
• Five minutes before the system is placed into the standby
mode, a message appears every minute.
Power Management (PC mode only)
The system will be automatically placed into the standby mode
when no signal is received from the personal computer.
1
Press HOME MENU.
2
Select "Power Control". ( /
3
Select "Power Management". ( /
4
Select "Mode1" or "Mode2". ( /
Item
Description
Off
No power management
(factory default)
Mode1
• Places the system into the standby mode when no
signal is received from the personal computer for
eight minutes.
• Even when you start using the computer and a
signal is received again, the system stays off.
• The system is switched on again by pressing
STANDBY/ON on the Plasma Display or TV
the remote control unit.
Mode2
• Places the system into the standby mode when no
signal is received for eight seconds.
• When you start using the computer and a signal is
received again, the system is switched on.
• The system is switched on again by pressing
STANDBY/ON on the Plasma Display or TV
the remote control unit.
5
Press HOME MENU to exit the menu.
then ENTER)
then ENTER)
then ENTER)
then ENTER)
then ENTER)
on
on
11
67
En
Publicidad
