Efco PT 2700 Manual De Instrucciones página 19

OPERATION
WARNING: Once the engine is warmed up do not
use the choke to start up again.
WARNING: Use the semi-acceleration device only in
the phase of starting the engine when cold.
• To start the engine when warm, switch (F) must be positioned
as shown in Fig.49.
47
WARNING: Do not cut material with the choke/fast
idle lever at the FULL CHOKE position. Do not
operate your pole pruner with the starting throttle
lock engaged. Cutting with the starting throttle lock
engaged does not permit the operator proper control
of the pole pruner or chain speed.
NOTE - STARTING WARM ENGINE:
48
Follow above starting instructions, but do not use the Full
Choke position for start up again. To set fast idle for warm
engine starting, pull choke out completely and push back in
to the original Run Position.
WARNING: Weather conditions and altitude may
affect carburetion. Do not allow bystanders close to
the pole pruner while adjusting the carburetor.
49
WARNING: Never attempt to start the pole pruner
when the guide bar is in a cut or kerf.
WARNING: Never start the pole pruner engine
without the bar, chain and sprocket cover assembled
- or else the clutch can come loose and cause
personal injuries.
en
19