Makita DBN500 Manual De Instrucciones página 8

Set the nail strip so that the nail tips touch the bottom of the
magazine slit and slide the nail strip toward the firing opening.
Return the slide door to the original position until the
lock lever locks it.
To remove the nails, press the lock lever and slide the
slide door. Take out nails from the magazine slit.
Nose adapter
CAUTION:
• Always make sure that your fingers are not
placed on the trigger, and the battery cartridge
and nails are removed before installing the nose
adapter.
3
1
► 1. Nose adapter 2. Protrusion 3. Center plate
4. Holder
When firing nails on the material to be fastened with easi-
ly-marred surfaces, use the nose adapter. To install the nose
adapter, place it over the center plate so that the protrusion
inside the nose adapter fits to the slit in the driver guide cover.
When not in use, store the nose adapter in the holder at
the back end of the slide door to keep it from being lost.
Total two nose adapters can be stored.
Hook
CAUTION:
• Always make sure that your fingers are not
placed on the trigger, and the battery cartridge
and nails are removed before using the hook.
• Do not hang the hook from the waist belt.
Dropping the nailer, which is caused by the hook
accidentally coming out of place, may cause
misfiring and personal injuries.
4
2
8 ENGLISH
► 1. Groove 2. Hook 3. Screw
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
Hex wrench storage
► 1. Hex wrench
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
OPERATION
Inspecting trigger function
CAUTION:
• Make sure that the trigger function is in working
order before each operation. If you find issues
described below, ask Makita Authorized Service
Centers for repairs.
• Before installing the battery cartridge into the
tool, always check to see that the switch trigger
actuates properly and returns to the "OFF"
position when released.
The tool must not operate only by pulling the trigger or
only by placing the contact element against the work
piece.
1
2
1