Ryobi RY40708 Manual Del Operador página 9

WARNING:
To prevent accidental starting that could cause serious
personal injury, always remove the battery pack from the
product when assembling parts.
CONNECTING THE UPPER AND LOWER
SHAFTS
See Figure 2.
 Remove the battery pack if installed.
 Loosen the two bolts on the coupler of the tool.
 Align the connector on the upper shaft of the tool with
the connector on the lower shaft of the tool.
WARNING:
Do not allow familiarity with products to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
WARNING:
Never use flailing devices, wire, or rope on this product.
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
NOTICE:
Before each use, inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts
are replaced. Please contact customer service or a quali-
fied service center for assistance.
ASSEMBLY
 Slide the connectors together and, using the hex key
provided, secure with bolts and nuts. Tighten securely.
NOTE: Orient the nuts so that they sit in the recessed
areas on the connectors.
ATTACHING THE FRONT HANDLE
See Figure 3.
 Remove wing nut from the front handle.
 Install the front handle onto the top side of the drive shaft
housing.
 Insert bracket tab into handle slot and align bracket hole
over handle bolt.
 Reinstall the wing nut.
 Tighten wing nut securely.
OPERATION
TO INSTALL BATTERY PACK
See Figure 4.
WARNING:
Always remove battery pack from your tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
 Insert the battery pack into the product as shown.
WARNING:
Make sure the latch on the battery pack snaps in place
and the battery pack is fully seated and secure in the
power head battery port before beginning operation.
Failure to securely seat the battery pack could cause the
battery pack to fall out, resulting in serious personal injury.
7 — English