Publicidad
)
START
I
s
[A]
(adjustment in Amperes).
maintained for the whole time during which the torch push-button is pressed
(adjustment in Amperes).
increase as to the pre-selected welding current value. This adjustment
)
START
t
s
[sec]
and t
parameters can be used even with remote commands
given from the pedal, but the adjustment must be made before activating the
command.
)
I
2
[A]
is the maximum current. The parameter is measured
2
in Amperes.
I
1
[A]
is measured in Amperes.
value of the pre-selected welding current. This adjustment improves welding
Hz
welding current.
( AC/DC model )
BAL
( DC model )
BAL
the time during which the current is at its highest level (main welding current)
if the parameter value is positive surface cleaning is greater and electrode
heat increases, while if the parameter value is null there is balance between
0.1 ÷ 10 s).
END )
2
2
is the current
1
, during welding. The value
2
t
e
[sec]
time during which the torch push-button is pressed.
that is
(adjustment 0.1 - 10 s), and protects electrodes and pool welding from
oxidation.
)
2
starting easier (adjustment 2.6 ÷ 53 A·sec.). The higher the value set, the
the remote control.
- "
installed).
- "
- "
protection triggered due to malfunction of the torch water cooling
seconds.
3- Control panel.
MMA - TIG LIFT
with the previous setting of 4.
.
increase as to the pre-selected welding current value. This adjustment
- 7 -
END )
I
e
[A]
[sec]
[A sec]
e
for the whole
e
Publicidad
