Slipper Clutch Adjustment Blx; Spur/Pinion Mesh Adjustment Blx - Arrma 1/10th SCALE 2WD BLX BRUSHLESS Manual De Instrucciones

Slipper Clutch Adjustment
ARRMA-RC.COM/
SUPPORT/
1
Factory Setting-Werkseinstellung-Réglage d'usine-Padrón- 出厂设置 - 出荷時設定
MEGA/BLS/BLX
1. Fully tighten locknut clockwise. Kontermutter festziehen im Uhrzeigersinn. Serrer l'écrou complètement. Apriete completamente con-
tratuerca en sentido horario. 完全锁紧螺母顺时针方向拧紧。完全にロックナットを時計回りに締め
2. Loosen 3 turns. Rückgängig 3 Umdrehungen. Desserrez les 3 tours. Afloje 3 turnos. 松开 3 圈。3 ターンを緩めます。
Spur/Pinion Mesh Adjustment
ARRMA-RC.COM/
SUPPORT/
1
© 2015 ARRMA Durango Ltd. A subsidiary of Hobbico, Inc.
Tools Required
2mm Hex Driver
2
WARNING: A loose slipper will damage the friction pads. If
the slipper is too tight it may damage the transmission.
Tools Required
2mm Hex Driver
2
11
5.5 & 7mm Nut Driver or Cross Wrench
5.5 & 7mm Nut Driver or Cross Wrench
3
WWW.ARRMA-RC.COM