Publicidad
Idiomas disponibles
Idiomas disponibles
29. Outer flange
30. Saw shaft lock
31. Inner flange
32. Laser
33. ON/OFF switch laser
34. Latched position lever
35. Tilt protection
36. Adjusting screw
37. Cable holder
38. Speed selector switch
A.) 90° stop angle (not supplied)
B.) 45° stop angle (not supplied)
C.) Allen key, 6 mm
D.) Philips head screw (Laser)
3. Scope of delivery
• Sliding compound mitre saw
• 1 x Clamping device (7) (preassembled)
• 2 x Workpiece support (8) (preassembled)
• Chip collection bag (17)
• Allen key 6 mm (C)
• Operating manual
4. Intended use
The sliding compound mitre saw is designed to cross-
cut wood and plastic respective of the machine's size.
The sliding cross cut mitre saw is not designed for cut-
ting firewood.
Warning!
Do not use the sliding cross cut mitre saw to cut mate-
rials other than those specified described in manual.
Warning!
The supplied saw blade is intended exclusively for saw-
ing the following materials:
wood, wood derived products (MDF, chipboard, ply-
wood, blockboard, hardboard, etc.), wood with nails
and 3 mm mild steel plates.
Note:
Wood containing non-galvanised nails or screws can
also be safely cut when carefully handled.
30 | GB
Note:
Do not use the saw blade to cut galvanised materials or
wood containing galvanised nails.
Do not use the saw blade to saw firewood!
The equipment is to be used only for its prescribed pur-
pose. Any other use is deemed to be a case of misuse.
The user / operator and not the manufacturer will be
liable for any damage or injuries of any kind caused as
a result of this.
The equipment is to be operated only with suitable saw
blades. It is prohibited to use any type of cutting-off
wheel.
To use the equipment properly you must also observe
the safety information, the assembly instructions and
the operating instructions to be found in this manual.
All persons who use and service the equipment have to
be acquainted with this manual and must be informed
about the equipment's potential hazards.
It is also imperative to observe the accident prevention
regulations in force in your area.
The same applies for the general rules of health and
safety at work.
The manufacturer will not be liable for any changes
made to the equipment nor for any damage resulting
from such changes.
Even when the equipment is used as prescribed it is
still impossible to eliminate certain residual risk factors.
The following hazards may arise in connection with the
machine's construction and design:
• Contact with the saw blade in the uncovered saw
zone.
• Reaching into the running saw blade (cut injuries).
• Kick-back of workpieces and parts of workpieces.
• Saw blade fracturing.
• Catapulting of faulty carbide tips from the saw blade.
• Damage to hearing if ear-muffs are not used as nec-
essary.
• Harmful emissions of wood dust when used in
closed rooms.
Please note that our equipment has not been designed
for use in commercial, trade or industrial applications.
Our warranty will be voided if the equipment is used in
commercial, trade or industrial businesses or for equiv-
alent purposes.
www.scheppach.com
Publicidad
