Publicidad
Step 2
Separate the EXTENSION SLIDES (45MC) from the EXTENSION RAILS (45MA) as
å
shown in the upper diagram below. Be prepared, the parts are greasy.
Fasten four EXTENSION RAILS (45MA) to the LEFT END (B) and LEFT UPRIGHT (D).
å
Use eight GOLD 5/16" FLAT HEAD SCREWS (3S).
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the
å
enlarged diagram. Then, slide the inner cartridge of the EXTENSION RAIL in to fi nd
the other hole that lines up with the hole in the LEFT END or LEFT UPRIGHT. Turn a
SCREW into this hole.
NOTE: The EXTENSION SLIDES will be used later for the LARGE DRAWERS.
å
Push the black lever in and pull the SLIDE from the RAIL.
Open end
www.sauder.com/services
45MC
B
3S
GOLD 5/16" FLAT HEAD SCREW
(8 used in this step)
D
109843
45MA
Long edge with
TWIST-LOCK®
FASTENERS
Open end
Page 7
Publicidad
