Upright 8000 Serie Manual Del Usuario página 21

4. Lower the Outriggers two at a time starting at the tow bar end (No's 3&4) until
the jockey wheel just clears the ground.
5. Lower Outriggers 1&2 until the green LED display indicates that they are
under load. (As shown below)
Take EXTREME care NOT to ground either the Basket, or the
!
Jockey Wheel during the next step.
6. Repeat this sequence for Outriggers 3&4.
7. By alternating from 1&2 to 3&4, carefully inch down each pair of Outriggers
until all four Outriggers are fully deployed, and the wheels are well clear of
the ground.
8. Now, by using the Level indicator (Fig.5), raise opposite Outriggers until the
bubble and indicator ring are concentric (i.e., the bubble rests in the centre).
9. Check that each LED on the Ground Control panel is still illuminated. This
indicates that each foot is in firm contact with the supporting surface.
The unit is designed to operate on a supporting surface of
minimum bearing strength of 50N/cm
The maximum outrigger load is 12.5kN.
TL49K
.
2
508159-000
SETTING UP
17