Publicidad
Idiomas disponibles
Idiomas disponibles
Spa Tub and Air Bladder (*Optional) Repair
Use the enclosed repair patch to repair any puncture:
1. Clean and dry the area to be repaired thoroughly
2. Apply the glue to the PVC patch and quickly attach it onto the damaged surface. (Glue is not included)
3. Smooth the surface to remove any air bubbles and allow it dry for 5-10 minutes
: Glue is not included.
NOTE
1
Storage and Preparation for Future Use
1. Drain and clean the spa by following the "Drainage" and "Spa Cleaning" sections.
2. Refer to the instructions to deflate the spa tub and air bladder (*optional).
3. Make sure all the spa components and accessories are thoroughly clean and dry before
storage. Air-dry the spa tub in mild sunlight for an hour before folding.
4. Fold the spa tub loosely and avoid any sharp corners to prevent damage or leakage to
the spa liner.
5. Prepare a new additional cartridge for next time use.
6. Store the spa and accessories in a dry, temperature-controlled storage area
(between 0°C and 40°C (32°F - 104°F).
7. The original packaging is recommended for storage.
PRECAUTIONS FOR SEASONAL USE
Inflatable hot tubs are made of reinforced PVC material, whose nature decides the hot tubs are easily affected by weather and temperature. Please do pay
special attention when using the spa under different seasonal conditions.
In Summer / Sunny days
Direct sunshine and hot weather will both lead the spa liner to expand.
●
To extend the service life of the spa, it is suggested to place the spa in a sheltered place.
●
Please check the air pressure regularly. The manometer should always point to the Green section when spa is filled with water. When leaving the spa
outdoors unattended for long periods of time, release some air until the manometer points to the Yellow section. This will prevent the spa liner from
expanding too much due to rising temperature during the daytime.
●
To protect your skin from sunburn, it is highly recommended to enjoy the spa in the morning or evening when the sunlight is milder and temperature is
more comforting.
●
Check the water temperature and consider lowering it for the times when the spa is not in use. Turn off the heater entirely if not using the spa for an
extended period of time.
Deflation Instructions
1. Unscrew the whole valve on the spa pool to deflate the spa.
2. Once it is deflated, replace the valve.
2
pin hole
pin hole
14
3
Publicidad
