mspa Meteor C-ME062 Manual De Instrucciones página 16

PROBLEM
Power socket failure
GFCI is off
NO DISPLAY ON THE
Press the Reset button, controller is not displayed
CONTROL PANEL
GFCI broken
Spa in&outlet connection not securely tight
Drainage valve is not closed completely
SPA LEAKING
Water leaks from the spa pool body
Temperature set too low
Dirty filter cartridge
NOT HEATING
Water level is not at the minimum water line
PROPERLY
Heater failure
Filter pump DOES NOT WORK
Air valve is loose
SPA LOSES AIR
Hole or split on the spa tub
Water has been used for long
period of time
Insufficient filtering time
WATER NOT CLEAN
Dirty filter cartridge
Improper water maintenance
SPA TUB IN AN
Extra air pressure due to strong sunlight
ABNORMAL SHAPE
Auto-off 10 minutes
Internal parts damaged
NO BUBBLE
One-way valve broken
Filter cartridge clogged by dirt or
FILTER PUMP DOES
other objects
NOT WORK
Filter system failure
Where can I find the serial number?
At the back of controller. Or at the foot of the control box.
How can I find my service contact?
* Scan the QR code below or visit https://www.the-mspa.com/after-sales.
1. Input the serial number of your spa.
2. The corresponding service provider will be displayed.
* You can find the contact information of local service center on the back of the warranty card
CONTACT YOUR LOCAL MSPA DEALER OR SERVICE CENTER FOR ANY PRODUCT-RELATED QUESTIONS OR PROBLEMS.
CAUSE
Change a socket or repair the socket before use
Reset the GFCI by following the GFCI Testing section
Contact local MSpa Service Center
Contact local MSpa Service Center
Tighten the in&outlet connection
Close the drainage valve. Contact the MSpa Service Center,
if spa is still leaking
Repair the leaking hole/split with the repair kit material
Set a higher temperature
Clean or replace the filter cartridge
Add more water to the minimum line
Contact local MSpa Service Center
Refer to the "FILTER PUMP DOES NOT WORK" section
Inflate the spa till Yellow section of the manometer is pushed out.
Make sure the valve is screwed tightly. Replace the valve if necessary.
Fill a squirt bottle with soapy water and spray on the seams. If there is a
leak, small bubbles will come out. When you have located the leak,
clean and dry the leaking area, then use the repair patch supplied with
your spa. Check the repair section on P14.
Change the water
Extend the filtration time
Clean or replace the filter cartridge in time
Refer to the chemical manufacturer's instructions
Check the air pressure and release air if necessary
During hot weather, it is advisable to check whether some air should be
released to avoid any possible damage to the spa pool.
Wait for 10 minutes and turn on the Bubble button again
Contact local MSpa Service Center
Contact local MSpa Service Center
Clean or replace the filter cartridge
Contact local MSpa Service Center
16
SOLUTION