Publicidad
Idiomas disponibles
Idiomas disponibles
Wear ear protection.
Wear a dust mask.
V
Volts
A
Amperes
Hz
Hertz
W
Watts
min
Watts
Alternating
Current
Date Code Position
The Date Code, which also includes the year of
manufacture, is printed into the housing.
Example:
2022 XX XX
Year of Manufacture Package Contents
USING AN EXTENSION CABLE
If an extension cable is requred, use an approved extension
cable suitable for the power input of this tool (see technical
data). The minimum conductor size is 1.5 mm
When using a cable reel, always unwind the cable
completely. Also refer to the table below:
Minimum gage for cord sets
Volts
Total length of cord in meters
120V
0-7
220V
0-15
Rated
Minimal cross-sectional area of the
Ampere
range
0-6A
1.0
6-10A
1.0
10-12A
1.5
12-16A
2.5
THE PACKAGE CONTAINS
1 1/2 Impact Wrench
1 Instruction manual
1 Warranty card
1 Service center list
Direct Current
n
No-Load Speed
0
Class II
Construction
Earthing
Terminal
Safety Alert
Symbol
Revolutions or
/min.
Reciprocation
per minute
.
2
7-15
15-30
30-50
15-30
30-60
60-100
cord in meters (mm
)
2
1.5
1.5
1.5
2.5
1.5
2.5
4.0
Not recommended
♦ Check for damage to the tool, parts or accessories
which may have occurred during transport.
♦ Take the time to thoroughly read and understand this
manual prior to operation.
Description (Figura A)
WARNING: Never modify the power tool or any
part of it. Damage or personal injury could result.
1.Forward/Reverse Rocker
2.1/2" Hog Ring Anvil
OPERATING INSTRUCTIONS
WARNING:
circumstances should this product be used near
water.
WARNING: Risk of lacerations or burns. Do not
touch work piece or accessory immediately after
operating the tool. They can become very hot.
Handle carefully. Always allow accessories and work piece
to cool before handling.
WARNING: To reduce the risk of injury, turn
unit off and disconnect it from power source
before installing and removing accessories,
before adjusting or when making repairs. An accidental
start-up can cause injury.
ATTACHING ACCESSORIES
CAUTION: Use only impact sockets. Non-impact
sockets may break and cause a hazardous
condition. Inspect socket prior to use to ensure
that it contains no cracks.
To install an accessory,firmly push accessory onto the
1/2" hog ring anvil (2) as shown in figure B. The hog ring
(3) compresses to allow the accessory to slide on. After
the accessory is installed, the hog ring applies pressure to
help provide accessory retention.
To remove an accessory, grasp the accessory and firmly
pull it off.
Operation (Figure C)
• Press the bottom part of the forward/reverse switch (1)
marked "F" to run the tool in a forward (right-hand thread)
direction.
2.5
• Pressing the top of the forward/reverse switch (1) marked
4.0
"R" to reverse the motor direction.
4.0
USE
WARNING: Ensure fastener and/or system will
withstand the level of torque generated by the
tool. Excessive torque may cause breakage and
possible personal injury.
1. Place the accessory on the fastener head. Keep the
tool pointed straight at the fastener.
2. Press forward/reverse switch (1) to start operation.
Always check torque with a torque wrench, as the
ENGLISH (
Original Instructions)
Shock
hazard.
Under
no
15
Publicidad
