Publicidad
Idiomas disponibles
Idiomas disponibles
5459520-Elektrotac-man_a 08.11.10 12:28 Seite 51
tool. When removing the trapped
staple, the stapler may be triggered
accidentally if it is still connected to
the power.
• Be careful when removing a
trapped staple. The mechanism may
be under tension and the stapled may
suddenly shoot out when you attempt
to release it.
• Never use the stapler to secure
electrical cables. It is not designed
for securing electrical cables and is
capable of damaging the insulation of
the cables and thus causing electrical
shock or a fire.
• Pull out plug before loading staples.
• Switch the appliance off before
inserting plug into socket.
• Ensure that the power cable is well
away from the appliance.
• Do not touch touch-sensitive switch.
• Never point appliance at people or
animals! Staples or nails fired at close
range may cause serious injury.
• Use only appropriate staples.
• Check the magazine lock before
using.
• During breaks in work push the lock
switch (1) to „O/Off".
• Wear ear protectors and protective
gloves.
• Do not use the appliance to fasten
down electric cables or leads.
7 – Installation and setting
Inserting staples/nails
Unplug from the power source!
Open the magazine lock (5) and pull the
slider out (Figure 2). Insert the
stable/nail strips into the magazine
(Figures 3 and 4). Push the slider back
into place and lock (Figure 5).
8 – Operation
It is normal for the unit to warm up
during operation, this is not a fault.
The device is triple secured against
accidental triggering:
Switching on
Set the switch (1) to the I setting.
Switching off
Set the device to 0.
Trigger
The trigger releases a single shot when
activated and then deactivates
automatically. For each additional shot,
the trigger must be activated again.
CAUTION! Set back, risk of
injury.
Trigger lock
▼
The contact switch (2) ensures that
the stapler can only be triggered when
in contact with the material. To do this
press the contact switch against the
workpiece, using both hands if
necessary.
51
Publicidad
