Publicidad
Idiomas disponibles
Idiomas disponibles
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package
and hardware contents list. If any part is missing or damaged, do not attempt to assemble the product.
Contact customer service for replacement parts. You could also contact us at partsplus@lowes.com.
Estimated Assembly Time: 30 minutes
Tools Required for Assembly (not included): Adjustable wrench and safety glasses.
Installation may vary depending on how the previous showerhead was installed. Supplies necessary
for the installation of the showerhead are not all included; however, they are available wherever
plumbing supplies are sold.
Prior to beginning installation, turn off the hot and cold water lines, then turn on the old shower to
release built-up pressure. When installing the new shower, hand tighten the connections. DO NOT
OVERTIGHTEN. Connections that are too tight will reduce the integrity of the system.
PRODUCT SPECIFICATIONS
Maximum flow rate: 1.8 GPM (6.81 LPM) at 80 PSI
cUPC, WaterSense
Chrome, brushed nickel, and matte black finishes
INSTALLATION INSTRUCTIONS
1.
Shut off the water at the main water supply. Remove the
existing showerhead (1.1) using a wrench, if needed.
Clean the threads on the shower arm (1.2).
2.
Apply thread seal tape (E) onto the threads of the shower arm
(2.1) in a clockwise direction.
Make sure a washer (D) is inserted into the magnetic shower
bracket (B). Hand tighten the the magnetic shower bracket (B)
to the shower arm (2.1). The open end of the magnetic shower
bracket (B) should be directed downward. Do not overtighten.
1
2
2.1
3
B
1.2
1.1
B
D
Publicidad
