Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
18.
Slide the assembled tubes down through the flaps in
the sides of the hopper bag (3) as shown in figure 11.
19.
Slide the assembled tubes back up underneath the
wind screen as shown in figure 12.
20.
Secure the top and bottom hopper tubes together
using two 5/16" x 3/4" hex bolts (17) on inside and
two 5/16" nylock nuts (21) outside. See figure 13.
21
FIGure 11
21.
Install two cotter pins (27) in the rear hopper tube.
Bend ends of cotter pins around tube.
22.
Slide the dump handle clip (33) onto the dump handle.
23.
Attach the dump tube to the rear hopper tube using a
U-clamp (34) placed between the cotter pins, a 1/4"
x 1-1/2" hex bolt (16) and a 1/4" nylock nut (24). See
figure 14.
24.
Swivel the dump tube so that the end of the tube
rests on the ground behind the bag and supports the
rear of the bag in an upright position.
FIGure 12
6
17
17
33
21
FIGure 13
24
34
16
27
5
FIGure 14
Publicidad
Tabla de contenido
