AKO -16523P Guía Rápida página 12

Keypad
Pressing it for 3 seconds activates/deactivates Stand-By mode. In this mode, regulation is paused and the
m icon is displayed.
In the programming menu, this exits the parameter without saving changes, returns to previous level or
exits programming.
Pressing once displays the temperature of probe S2 for 10 seconds (If it is enabled).
Pressing it for 3 seconds starts/stops the defrost.
In the programming menu, this allows scrolling around the different levels, or, during the setting of a
parameter, changing its value.
Pressing it for 3 seconds activates/deactivates continuous cycle mode.
In the programming menu, this allows scrolling around the different levels, or, during the setting of a
parameter, changing its value.
Pressing once activates/deactivates the cold room light.
Pressing it for 3 seconds accesses the condensed programming menu.
Pressing it for 6 seconds accesses the expanded programming menu.
In the programming menu, this accesses the level shown on the display or, during the setting of a
parameter, accepts the new value.
Pressing once displays the current effective value of the Set Point, taking into consideration temporary
modifications by other parameters (C10 ó C12).
When an alarm is underway, pressing once mutes the acoustic alarm.
Pressing for 3 seconds accesses the Set Point setting.
Indicators
Fixed: Stand-By Mode activated. Regulation is
paused.
Flashing: Controlled shutdown process for the
regulation underway.
Fixed: Cold room door open.
Flashing: The door has been open for a greater
time than has been defined in parameter A12.
There is an active alarm, but not an active HACCP
alarm.
Fixed: HACCP alarm active.
Flashing: HACCP alarm registered and
unconfirmed. Press the
HACCP alarm.
Fixed: Evaporator fans active.
Flashing: The evaporator fans should be active
but a delay is preventing this.
Fixed: The cold solenoid is active.
Flashing: The solenoid should be active but a
delay or protection is preventing this.
STAND-BY
If the regulation cannot be instantly stopped due to its configuration, a controlled stop process starts
and the m icon flashes. To stop the controlled stop process and force the step to Stand-by, press the
Stand-by key again for 3 seconds.
Fixed: Compressor active.
Flashing: The compressor should be active but a
delay or protection is preventing this.
Defrost relay active.
Continuous cycle mode active.
Cold room light active.
Alarm underway muted.
Temperature displayed in ° Fahrenheit /
° Centigrade.
Programming mode active.
key to confirm an
Fixed: CAMM module in operation.
Flashing: Malfunction in CAMM module.
Bluetooth activated (CAMM module only).
12
1652H311 Ed.11