Auxiliary Handle - Bosch 1191VSRK Instrucciones De Funcionamiento Y Seguridad

2610048704.qxp_1191VSRK 10/5/17 10:12 AM Page 8
VARIABLE SPEED CONTROLLED
TRIGGER SWITCH
Your tool is equipped with a variable speed trigger
switch. The tool can be turned "ON" or "OFF" by
squeezing or releasing the trigger (Fig. 1).
The speed can be adjusted from the minimum to
maximum nameplate RPM by the pressure you
apply to the trigger.
Apply more pressure to increase the speed and
release pressure to decrease speed.
DRILL/HAMMER DRILL
SELECTION SWITCH
The selector switchl allows the tool to be set
for various drilling/hammer
applications. Rotate the selector dial right or
left depending on the below applications (Fig. 1).
tool come to a complete stop. Shifting
during rotation of the chuck can cause
damage to the tool.

AUXILIARY HANDLE

The auxiliary handle will provide additional
control, support and guidance for the tool. The
handle is adjustable around the 360° handle
collar mount. To mount, loosen wing knob and
slide handle completely over chuck onto the
collar mount and tighten wing knob (Fig. 4).
Operating Instructions
FIG. 2
drilling
Do not operate the
selection dial until the
REVERSING SWITCH BUTTON
The reversing switch button is located above
the trigger switch and is used to reverse
rotation of the bit.
For forward rotation, (with the chuck pointed
away from you) move button to the far left
(Fig. 2). For reverse rotation move the button to
the far right. (Fig. 3)
Do not change direction of
rotation until the tool comes
to a complete stop. Shifting during rotation of
the chuck can cause damage to the tool.
Do not use demolition or chipping bits such
as bull points, chisels, spades, gouges, etc.
Drill only action: For drilling in woods,
metals, plastics or other non concrete
materials.
Drill with hammer action: For drilling
in concrete, asphalt, tile or other
similar hard materials.
FIG. 4
AUXILIARY
HANDLE
-8-
FIG. 3
WING KNOB