MotionBlinds CM-09 Guía De Configuración página 20

Problem
Blind does not work.
Multiple blinds respond to a
remote. (Unable to program
a single blind)
Blind moves in small steps.
Favourite position can not
be programmed.
Blind lowers too far.
Blind moves in the opposite
direction.
The blind keeps moving up
and down.
The blind firmware will not
update to the latest version.
Cause
Power supply is not connected.
Remote battery is empty. (LEDS of remote are
flashing rapidly.)
Remote battery is inserted incorrectly.
Radio-frequency interference
The distance from the phone/bridge/remote to
the motor is too far.
The remote is not connected to
the blind.
Multiple blinds are paired with a single channel.
1) No end limits are programmed.
2) Direct control is deactivated.
No end limits are programmed.
End limits are programmed incorrectly.
The rotational direction has been
set incorrectly.
The blind is in program mode.
The blinds bluetooth connection is not stable.
Solution
Connect the power supply to the motor.
Replace the battery in the remote.
See the manual of the remote.
Replace the battery in the remote.
See the manual of the remote.
Make sure that the antenna of the motor is out of the
way of metal objects.
Move closer to the motor.
Pair the remote with the motor.
See page 9.
Pair the blind with a free channel to program or use
single select to program the blind.
1) Program end limits. See page 7, 15-16.
2) Activate direct control. See page 18.
Program end limits.
See page 7, 15-16.
Reprogram end limits. See step 7, 15-16.
Change the rotational direction.
See page 14.
Press the program button on the motor
to exit program mode.
Close the app and reconnect with your motor.