Favero Electronics FS-1 Serie Manual De Uso página 11

connected to this control board. Keeping in mind their original positions, remove all connectors from the control
board.
5. With a 5.5 mm wrench, unscrew the 4 nuts from the control board (Fig. 8.4) and remove the control board from
its casing.
6. Set the dip-switches of the new control board to the same settings of those of the control board you replaced
(see chapter 9) and screw the new board into the casing.
7. Reinsert the control board's connectors into their original positions; replace the metal support base of the
display board on the bottom of the scoreboard and fasten it with the end nuts provided.
8. Replace and tighten the front panel to the board.
9. Supply power to the board again to check if the module works properly.
Fig. 8.3:
F E S
AVERO LECTRONICS RL
Replacing a control board (side view)
11 / 56 00236-M02-03-ML - Series FS-1xxN scoreboard installation
Fig. 8.4:
Control board
ENGLISH