Publicidad
Idiomas disponibles
Idiomas disponibles
HEPA FILTER
1. Open air outlet plate and remove filter. Fig.18
2. Clean up filter by shaking it.
For best performance, replace filter every 6 months.
Never use appliance without water tank and motor protection filters installed.
18
Carry your vacuum cleaner by holding it from its handle.
Using only original accessories and parts is essential for an efficient cleaning and for device life.
Supply accessories and parts only from the nearest authorized service if neccesary.
CAUTION:
• Only make dry sweeping with your vacuum cleaner.
• If the line cord is damaged, it must be replaced by the manufacturer or an
authorized service center.
• Absolutely make the certificate of warranty confirmed by an authorized dealer
begining from date of sale (title stamp and date of sale).
STORAGE
Before storing your vacuum, the water tank should be emptied and cleaned. Accessories may
be stored with vacuum. The vacuum should be stored indoors. Do not use to vacuum toxic
materials. Review frequently, do not use vacuum with a saturated water tank.
Always use the unit with the filters when vacuuming.
IMPORTANT
After cleaning the filter, check for holes. If any holes are found replace the filter immediately.
Even small holes will permit dust to come out of the vac.
TROUBLESHOOTING
ISSUE
Motor doesn´t start.
Suction power is decreasing.
Dust filtration
Cable does not rewind completely.
19
Filter or hose obstructed.
Inadecuate level in power reader.
Water tank level is low or
inadecuate.
Verify that cable is not
bent or knotted.
20
FIX
Remove object.
Position at desired suction level.
Verify water level.
See page 6.
Pull out cable 3 feet.
Pull down cable and press rewind
switch.
7
Publicidad
