Alarm Display - JVC BR-DV3000E Manual De Instrucciones

ON-SCREEN DISPLAY
Alarm display : Alarm messages are displayed as shown below, when an operation
Display at position A : Displays which show the state of the unit (and which are not set
Display
LOW VOLTAGE
HEAD CLEANING
REQUIRED!
OVERHEATING!
Display at position B : Messages indicating operation errors are displayed for about 3
Display
INVALID TAPE!
LP TAPE!
NO DV SIGNAL
E-22
error has occurred or when the unit is in a poor condition for operation.
E.g., dirty head.
3 2 K C H – 1 / 2
A
H E A D C L E A N I N G R E Q U I R E D !
B
N O D V S I G N A L
1 0 / 1 0 / 0 2
1 2 : 0 0 : 0 0
via the DISPLAY mode) continues to be displayed here until the
conditions are rectified.
The voltage of the DC input power is low. Continued operation will bring the unit to the
Operate OFF mode.
The video head is dirty. Please clean it with the dedicated head-cleaning tape.
☞
( Page 8)
If the head is clogged, it will be detected in the PLAYBACK mode and displayed.
When the unit enters the STOP mode or the cassette is ejected, the display goes off.
The temperature inside the unit has exceeded the regulated value.
Please disconnect the power and place the unit in a cool place.
If this message is displayed again, damage may have occurred. Please consult with
your JVC-authorized service agent.
seconds.
They are displayed when the DISPLAY mode is ON or AUTO.
Data tapes for PC use or DVC PRO tapes has been inserted.
The cassette will be ejected.
The user attempts to play back a tape recorded in the LP mode.
This unit cannot record or play in the LP mode.
The user attempts to record without DV signal input.

Alarm display

–
0 0 0
S P
S T A N D B Y - O F F
T C R 0 2 : 0 0 : 0 0 : 0 0
Contents
Contents
–
m i n