Parkside PNKP 105 B1 Traduccion Del Manual De Instrucciones Originale página 9

Original accessories/auxiliary equipment
♦ Only use the accessories and additional equipment that are
specified in the operating instructions and compatible with the
appliance.
Operation
Preparing the surfaces to be glued
■ Do not use flammable solvents to clean the surfaces to be glued.
■ The ambient temperature and the materials to be bonded may
not be colder than 5°C and not warmer than 50°C.
■ The area to be glued must be clean, dry and free of grease.
♦ Smooth surfaces should be roughened before gluing.
♦ Quick-cooling materials such as steel should be warmed a little
to facilitate adhesion.
1. Fold out the stand 4. Put down the appliance.
2. Push a glue stick 7 into the feeder shaft 1.
3. Allow the appliance heat up for about 5 minutes.
The appliance is now ready for use.
Preparing the surfaces to be glued
Pull the trigger 3 to regulate the flow of glue in accordance with
♦
your requirements.
1. Apply the glue in spots. For flexible materials, such as textiles,
apply the glue in zigzag lines.
2. Press the two workpieces to be bonded together immediately
after applying the glue and hold for about 30 seconds. The
glued bond is ready after about 5 minutes.
3. During breaks in work, put the glue gun down on the stand 4.
│ GB │ IE
■ 6
PNKP 105 B1