EGO HTA2000-FC Manual Del Operador página 28

LUBRICATING THE BLADES (Fig. 18)
For best operation and longer blade life, lubricate the hedge trimmer blades with light-
weight machine oil before and after each use.
18
1. Remove the battery pack from the hedge trimmer.
2. Lay the hedge trimmer on a flat surface. Apply some light-weight machine oil along
the edge of the top blades. If you will be using the hedge trimmer for an extended
time, it is advisable to take a break, remove the battery, and oil the blades.
If the upper blades are aligned completely with the lower ones, start the hedge trimmer
and then stop it to offset the blades before lubrication.
WARNING:
WARNING:
nonslip, heavy-duty protective gloves. Do not place your hand or fingers
between blades or in any position where they could get pinched or cut. NEVER
touch blades or service the unit with battery pack installed.
TRANSMISSION GEARS LUBRICATION
The transmission gears in the gear case need to be lubricated periodically with gear
grease. Check the gear case grease lever approximately every 50 hours of operation by
removing the sealing screw on the gear case. There are three sealing screws: one on
the side and two on the top.
If no grease can be seen on the flanks of the gear, follow the steps below to fill with
gear grease to 3/4 capacity.
Do not completely fill the transmission gears.
28
HEDGE TRIMMER ATTACHMENT — HTA2000/HTA2000-FC/HTA2020/HTA2020-FC
Upper Blade
Do not oil while the hedge trimmer is running.
Blades are sharp. When handling the blade assembly, wear
Lower Blade