Electrical Safety - Dimas FS500F Manual De Explicaciones

5
Check before starting
Please read the instructions for
use prior to operating the
machine for the first time.
Motor off.
The working area must be
completely cleared, well lit and
all safety hazards removed (no
water or dangerous objects in
the vicinity)
The operator must wear
protective clothing appropriate
to the work he is doing. We
recommend that this includes
both eye and ear protection
The use of ear protection is
mandatory.
Any persons not involved in the
work should leave the working
area
Use only blades marked with a
maximum
greater than blade shaft speed
PETROL OR DIESEL MOTOR
Take into account the working
conditions from health and safety
point of wiew.
Diesel :
15
MACHINE WITH ELECTRIC MOTOR
6
operating speed

- ELECTRICAL SAFETY :

- The RCCB must be used
correctly, including testing it
regularly. For tools supplied
with an integral RCCB in the
cable or in the mains plug, if
the cable or plug has been
damaged, repairs must be
carried out by
manufacturer, one of his
agents or by a qualified
repair workshop to avoid any
risks resulting from errors.
Fitting the blade
Disconnect the power plug
Take care about the direction of
rotation which is shown by an
arrow on one of the faces
(direction of rotation on the right
side of the casing)
Make sure the contact faces of
flanges, of blade and the axle are
clean
The disk clamping screw (D) has
a left-hand thread.
For your own safety and for the
protection of other people,
replace all the protective
devices.
7 Starting up
Danger: risk of injury
Always pay extreme care and
attention to the preparation of
the machine before starting up
Remove all adjustment tools and
wrenches from
machine
Always keep blade guard in
place
[SEE FIG. 1]
[SEE FIG. 1] (optional isolating valve).
the
Petrol and Diesel
- Automatic version
Abundant water cooling =
guaranteed long blade life
Automatic Advance
floor and