Edimax EDIM-0050 Manual De Instrucciones página 8

Charging indicator light
•Red indicator:charging.
•Red & yellow & green indicator: charging complete.
•About the charger:
Always disconnect the charger from socket when it is notin use.
Don't charge the battery more than 5 houra. Do not expose the charger to rain or
water. The charger must be used with the recommended product.
Never allow the battery pack to become fully discharged. This will cause it to
develop a defect.
On/Off Switch
•Use the On/Off switch to start the machine and keep holding it for continuous
operation.
•To switch the machine off, release the On/Off switch.
•The slide switch above the On/Off switch is for setting the direction of rotation of
the cordless screwdriver and for preventing the cordless screwdriver from being
switched on inadvertently.
•You can select between clockwise and counterclockwise rotation. Change the
direction of rotation only when the equipment is at a standstill. If you fail to observe
this point, the gearing may become damaged. When the slide switch is in the
middle position, the On/Off switch is blocked
•You can select between clockwise and counterclockwise rotation. Change the
direction of rotation only when the equipment is at a standstill. If you fail to observe
this point, the gearing may become damaged. When the slide switch is in the
middle position, the On/Off switch is blocked.
LED light
• The LED work light (4) and torch light (9) can be used in poor lighting conditions
to illuminate the area where you want to screw.
On/Off switch controls the LED work light (4) ON/OFF.
Push on the lens to turn the light on; push on the lens again to turn it off.
Don't put the light point-blank in yours or others eyes.
E N G L IS H
-