cecotec PAPRIKA 2000 Manual De Instrucciones página 15

ENGLISH
1. PARTS AND COMPONENTS
Fig. 1
1. Base
a. Power knob
2. Food pusher
3. Processing vessel lid
4. Tool holder
5. Processing vessel
6. Cutting blades unit
7. Kneading blade
8. Blade holder disc
9. Fine grinding blade
10. Thin cutting blade
11. French fries blade
12. Emulsifying disc
NOTE:
The graphics in this manual are schematic representations and may not exactly match the
device.
2. BEFORE USE
- This device is packaged in a way as to protect it during transport. Take the device out
of its box and remove all packaging materials. You can keep the original box and other
packaging elements in a safe place. This will help you prevent damage to the device when
transporting it in the future. In case the original packaging is disposed of, make sure all
packaging materials are recycled accordingly.
- Make sure all parts and components are included and in good conditions. If there is any
piece missing or in bad conditions, contact the official Cecotec Technical Support Service
immediately.
- Clean components that will come into contact with food with water and a non-abrasive
detergent before first use.
Box content
- Food processor
- Kneading blade
- Cutting blade
- French fries blade
28 PAPRIKA 2000
- Mincing blade
- Grating blade
- Emulsifying disc
- Blades support
- Instruction manual
3. ASSEMBLY
To carry out the assembly of the food processor, you must take into account that depending on
the food you want to process, you will have to use one or other components. In general terms,
however, the steps to be taken are as follows:
1. In any case, you must first place the container on the base so that it fits into the grooves
and the position of the container is fixed and stable.
2. Then, place the tool holder on the motor shaft so that it is fixed and the two parts rotate
with each other.
3. On the tool holder place the blade of your choice, whether it is a cutting blade, a kneading
blade, the stirrer or the disc holder with the different options that fit into the recess of the
holder for processing food.
4. If using any type of blade, the lid should be placed over the processing bowl and, if
necessary, push the food into the recess to press it against the disc holder. The lid is fixed
on the bowl, so it does not move and is stable, just like the rest of the components.
4. OPERATION
The power selector has three modes or speeds:
- Speed mode 1 is usually powerful enough to grind any food. It is used in all cases at the
beginning of processing.
- If necessary, due to the hardness or shape of the food, you can use speed mode 2 to give
extra power to the processor.
- PULSE mode, indicated by a P on the selector, sets the processor to full power while it is
active. It is used in cases where you want to chop or grind something hard that requires
powerful but short impacts.
The processor is designed for shredding in various forms, chopping, squeezing and kneading.
5. CLEANING AND MAINTENANCE
Cleaning
- To clean the blades properly, first rinse the jug with water. Fill the jug with 400 ml of
ENGLISH
PAPRIKA 2000 29