Publicidad
Idiomas disponibles
Idiomas disponibles
(*): Min. 6 in. (152 mm), Max. 8 in. (203 mm)
STEP 6 Remove the film inside the door
B
STEP 7 Power on
Plug the power cord into an AC 120 V / 60 Hz / 15 AMP approved electrical outlet protected by a fuse or
circuit breaker. Then, press Power to turn on the washer.
WARNING
• Do NOT use an extension cord or power strip.
Untitled-4 27
A
*
A
A
3. Route the drain hose to the drain system.
CAUTION
• If using a standpipe, make sure the standpipe and
drain hose connection is not airtight.
• If using a standpipe, make sure the drain hose is
inserted at least 6 in. (152 mm) but no more than 8 in.
(203 mm) into the standpipe.
4. Secure the drain hose with cable ties.
Over the edge of a wash basin
The drain hose must be placed no lower than 24 in. (60
cm) and no higher than 35 in. (90 cm) from the floor. To
keep the spout of the drain hose bent, use the supplied
plastic hose guide (A). Secure the guide to the wall using
a hook to ensure stable drainage.
Remove the small circle of film (B) above the door latch
before use.
English 27
2023-08-07
12:16:51
Publicidad
