Publicidad
Idiomas disponibles
Idiomas disponibles
1. Introduction
Manufacturer:
Adeo Services
135 rue Sadi Carnot
CS 00001
59790 Ronchin
France
Dear Customer,
We hope your new tool brings you much enjoyment
and success.
Note:
According to the applicable product liability laws, the
manufacturer of the device does not assume liability
for damages to the product or damages caused by
the product that occurs due to:
• Improper handling,
• Noncompliance of the operating instructions,
• Repairs by third parties, not by authorized service
technicians,
• Installation and replacement of nonoriginal spare
parts,
• Application other than specified,
• A breakdown of the electrical system that occurs
due to the noncompliance of the electric regu
lations and VDE regulations 0100, DIN 57113 /
VDE0113.
We recommend:
Read through the complete text in the operating in
structions before installing and commissioning the
device. The operating instructions are intended to
help the user to become familiar with the machine
and take advantage of its application possibilities in
accordance with the recommendations. The operat
ing instructions contain important information on how
to operate the machine safely, professionally and
economically, how to avoid danger, costly repairs, re
duce downtimes and how to increase reliability and
service life of the machine.
In addition to the safety regulations in the operating
instructions, you have to meet the applicable regula
tions that apply for the operation of the machine in
your country. Keep the operating instructions pack
age with the machine at all times and store it in a
plastic cover to protect it from dirt and moisture. Read
the instruction manual each time before operating the
machine and carefully follow its information. The ma
chine can only be operated by persons who were in
structed concerning the operation of the machine and
who are informed about the associated dangers. The
minimum age requirement must be complied with.
28 | GB
In addition to the safety notes contained in the pre
sent operating instructions and the special regula
tions of your country, the generally recognized techni
cal rules for the operation of woodworking machines
must be observed.
We accept no liability for damage or accidents which
arise due to nonobservance of these instructions
and the safety information.
2. Layout (Fig. 1, 2)
1. Drain plug for condensation water
2. Pressure vessel
3. Wheel
4. Supporting foot
5. Quicklock coupling (regulated compressed air)
6. Pressure gauge (for reading the preset vessel
pressure)
7. Pressure regulator
8. ON/OFF switch
9. Transport handle
10. Safety valve
A. Hex bolt
B. Nut
C. Washer
D. Flange nut
E. Holder
3. Scope of delivery
•
Wheel
•
Supporting foot
•
Holder
•
Assembly material
•
Operating manual
m ATTENTION!
The device and packaging materials are not toys!
Children must not be allowed to play with plas-
tic bags, film and small parts! There is a risk of
swallowing and suffocation!
• Open the packaging and remove the device care
fully.
• Remove the packaging material as well as the pack
aging and transport bracing (if available).
• Check that the delivery is complete.
• Check the device and accessory parts for transport
damage.
• If possible, store the packaging until the warranty
period has expired.
Publicidad
