JVC KW-ADV792 Manual De Instrucciones página 20

Menu item
Fader/Balance
Volume Adjust * 1
Subwoofer Level
High Pass Filter
Crossover
Amplifier Gain * 2
* 1
For "DISC/USB": You can make the adjustments separately depending on the audio format—Dolby digital, MPEG
Audio, and the others.
2
* The volume level automatically changes to "VOL 30" if you change to <Low> with the volume level set higher than
"VOL 30."
20
Fader : Adjust the front and rear speaker output balance.
• When using a two-speaker system, set the fader level to "0."
♦
F6 to R6; Initial 0
Balance : Adjust the left and right speaker output balance.
♦
L6 to R6; Initial 0
5 ∞ 2 3
Press [ / / / ] to adjust.
Fader/Balance
Back
Adjust and store the auto-adjustment volume level for each source, comparing
to the FM volume level. The volume level will automatically increase or decrease
when you change the source.
• <Fix> appears if " TUNER/Bluetooth PHONE" is selected as the source.
♦
–12 to +12; Initial 00
Adjust the subwoofer output level.
♦
–06 to +08; Initial 00
♦
Through : Select when the subwoofer is not connected.
♦
On : Select when the subwoofer is connected.
Select the crossover frequency between the front/rear speakers and the
subwoofer.
♦
80Hz, 120Hz, 150Hz
You can change the maximum volume level of this unit.
♦
Off : Deactivates the built-in amplifier.
♦
Low : VOL 00 to 30 (Select this if the maximum power of the
speakers is less than 50 W.)
♦
High : VOL 00 to 50
Selectable setting/item
Fader
Balance 0
Initial: Underlined
Reset
0