Descargar Imprimir esta página

AENO DB1S Guia De Inicio Rapido página 8

Ocultar thumbs Ver también para DB1S:

Publicidad

the toothbrush only on the original charging base. Avoid dropping the
charging base into water. If the charging base accidentally fell into water,
disconnect it from the power supply and then remove it from the water and
dry thoroughly. Each family member should use an individual replacement
brush head. Replace the brush head at least once every three months. Use only
the original replacement brush heads. Do not allow children to play with the
device and its accessories. When not in use for a long time, charge the device
every 2–3 months to prevent a deep discharge of the battery.
Preparing the device for operation
Charging. Unpack the device and place the charging base (10) on a dry, stable
horizontal surface. Connect the charging base to a power source using the USB
cable (11). Place the handle (2) on the charging base (10). The LED indicator (9)
will start to flicker * green.
When the LED indicator (9) turns solid green, the battery is fully charged, the
device is ready for operation. When charging is complete, disconnect the
charging base from the power supply.
Installing the brush head. Remove the handle (2) from the charging base (10).
Place the brush head (1) on the handle (2), pressing lightly until you hear a
distinctive click. When properly installed, there should be a small gap between
the handle of the toothbrush and the brush head (see fig. B).
LED charge indicator statuses
Indicator colour (9)
red
green
Configuring the device operation modes
Turn on the device by pressing the power button (3) once. Subsequent presses
of the button will switch operating modes. You can change the mode within
5 seconds after turning on the device. The last used mode is saved in the device
settings the next time the device is turned on.
* The indicator is on for 3,000 ms and then is off for 300 ms.
8
Battery charge level
low
medium/high
aeno.com/documents

Publicidad

loading

Este manual también es adecuado para:

Db2sAdb0001sAdb0002s