Publicidad
Idiomas disponibles
Idiomas disponibles
To attach belt clip (Fig . 3)
The belt clip can be installed on the left or
right side of the nailer, depending on operator
preference.
a. Remove the battery pack from the tool.
b. Align the belt clip and the screw hole on the
right or left side of the nailer.
c. Use the smaller hex key (included) to
tighten the screw securely.
No-mar pad (Fig . 4)
WARNING
removing or replacing the no-mar pad .
Failure to do so could result in serious
personal injury .
The no-mar pad attached to the nose of the
tool helps prevent marring and denting when
working with softer woods.
a. Remove the battery.
b. Remove the used pad by pulling it away
from the nose.
c. To replace the pad, fit it into place over the
nose and push up to reseat.
On-board storage for the pad is located on the magazine of the tool. A spare no-mar pad is
provided in the on-board storage area.
Remove the battery pack
from the tool before
Fig. 3
Fig. 4
Belt Clip
Screw for Belt Clip
No-mar Pad
Spare No-mar Pad
No-mar Pad Storage
13
Publicidad
