Publicidad
Idiomas disponibles
Idiomas disponibles
English
2. Control panel
2.1 Audio input
Combo XLR-1/4" balanced line input
This combo connector allows for the connection of an analog audio source (i.e., mixer/audio interface bal/unbal
line out). Connect professional equipment with balanced outputs to the XLR or 1⁄4" TRS input of the speaker
using balanced signal cables.
2.2 ARC Mic input
Use this female XLR to connect the ARC microphone that will allow you to perform a custom calibration of the
speaker to perfectly fit your environment.
2.3 Level
This control allows you to adjust the input level of the audio source from -5dB to +5dB.
2.4 USB port
This USB type-B port is used for service purposes, such as Firmware updates or factory checks, or to remotely
control the iLoud Precision via its Control Software.
2.5 Control I/O
These 3.5mm jacks are used to connect the optional remote controller. The controller will be connected to the IN
port, and then the OUT port will be connected to the IN port of the other speaker to control it: this lets you daisy
chain all of the speakers that are included in the system.
2.6 Power
Power switch: this switch allows you to power on and off your iLoud Precision.
Power AC: connect the (included) power cord to this AC socket.
IMPORTANT: before attempting to connect/disconnect the power cord, make sure that the power switch is set to
Off.
3. Rear controls
The pushbuttons on the back panel will help you to perfectly match iLoud Precision to every acoustic
environment. Also, the LEDs on the back panel have two level of brightness.
When operating the buttons the LEDs are lighted up at maximum intensity.
After 10 seconds of no operations on the buttons the LEDs will be dimmed.
The first push of the button will bring the brightness back to normal value but will not activate any of the
functions, including the "hold" ones: the first button press, after 10 seconds of no operations, will only "wake
up" the panel.
11
Publicidad
