Black and Decker BCD6W Manual De Instrucciones página 10

ENGLISH
SET UP & USE
QUICK CONNECT ASSEMBLY
Drain Hose:
1. Drain port connection
2. Quick connect connection
Inlet Hose:
3. Inlet port connection
4. Quick connect connection
Faucet Adapter
5. Faucet adapter
6. Faucet washer
1. Screw the faucet adapter onto (or into) the faucet tap. Check for leaks (use Teflon
tape to eliminate if necessary).
2. Connect the six-sided connection of the drain hose to the drain port connection
on the back of the dishwasher cabinet. Do not over-tighten (to avoid damage to
threads).
3. Connect the star-shaped connection of the inlet hose to the inlet port on the back
of the dishwasher cabinet. Do not over-tighten (to avoid damage to threads).
4. Connect the circular connection of the drain hose onto the longer (bottom) male
connection on the quick connect.
5. Connect the circular connection of the inlet hose onto the shorter (top) male
connection on the quick connect.
6. Attach the quick connect onto the faucet adapter, by pulling down the outer
locking collar on the quick connect, while pushing the quick connect upward onto
the faucet adapter.
7. When the quick connect snaps onto the faucet adapter, release the locking collar.
Verify the connection is secure.
8. Slowly open the hot water line and check for any sign of water leaks at all hose
connections. If leaks are located, immediately close the water supply and repair the
hose connections.
Page 10
WARNING
In order to avoid water staying in the inlet hose,
please close the faucet after using.
Quick Connect
7. Pressure relief valve
8. Faucet adapter connection
9. Locking collar
10. Inlet hose connection
11. Drain hose connection