Publicidad
Idiomas disponibles
Idiomas disponibles
English
button for manual feeding d programming buttons e container
cover f feed container g slider for feed dispensing h Velcro tape
as a fastener i Holder j Holder screw.
B
Setup
To insert the batteries (2 x "AA/LR6" size 1.5 V alkaline batteries), open the
housing cover by applying light pressure on the locking clip. Pay attention
to the proper poling of the batteries.
Attention: do not use rechargeable batteries.
Closing the housing cover: Insert into the upper edge of the drive unit and
pivot downwards until the lock engages.
Changing batteries: If the symbol
that the batteries are almost empty. The feeding procedure will still be car-
ried out, but the batteries should now be replaced. After about 3 days, the
entire display will blink and the device will shut off automatically in order to
prevent the feed container stopping in a downward position.
Please note: Replace the batteries within one minute to ensure that
none of the settings programmed are lost.
Velcro tape: The supplied Velcro tape can be used as a means of fastening
the automatic feeder to the aquarium.
Attachment: The most suitable place for mounting the holder is on the
edge of the tank with open aquariums.
C
Programming
The feed mode offers 3 possibilities which are shown in the upper line
of display to the right of the feed digits 1- 4:
No arrow = The time is stored but no feeding occurs.
1 arrow = The feed container rotates once.
2 arrows = The feed container rotates twice with a 1 minute interval.
This extends the time interval for feeding without engag-
ing additional feeding times.
General programming rules:
MODE switches initially between the current time and the feeding
times 1 to 4 consecutively. The current time is displayed whenever
you see the blinking double point; the feeding times are differenti-
ated by the digits (1 - 4) on the upper section of the display.
SET allows the respectively displayed times to be changed. With
MODE, the displayed time can be changed between hours and mi-
nutes, and feeding mode. The respectively effected symbol (either
time or feeding mode) blinks and can be set to a higher number with
the » + button «. SET stores the respective time which has been set,
LO
appears on the display, it means
- 12 -
Publicidad
