Publicidad
To connect to a team
You cannot connect to a team if no team is set up.
To set up a team, refer to
devices on page 10 . You can connect to a team at the
same time a new team is set up. You can also connect
to a team if a member of the team adds new devices to
the team.
1. Push the mode button for 1 second to enter the team
management mode.
Note:
An audio message tells you that you are in
team management mode. Refer to the table below.
Audio message
TEAM MANAGEMENT
2. Push the volume up button.
Note:
The pairing operation starts when you hear
a beep sound and the Bluetooth
slowly. The pairing operation is on for 1 minute. An
audio message tells you that you are connected to
the team. Refer to the table below.
Audio message
CONNECTED TO
TEAM
Note:
You can speak to the team after the audio
message tells you that you are connected to the team.
To disconnect from a team
1. Push the mode button for 1 second to enter the team
management mode.
Note:
An audio message tells you that you are in
team management mode. Refer to the table below.
Audio message
TEAM MANAGEMENT
2. Push the volume down button.
Note:
An audio message tells you that you have
disconnected from the team. Refer to the table
below.
Audio message
LEAVING TEAM
1957 - 002 - 09.10.2023
To set up a team and add
LED indicator on the
®
Bluetooth
button
Solid white.
®
button flashes
LED indicator on the
®
Bluetooth
button
Solid green.
LED indicator on the
®
Bluetooth
button
Solid white.
LED indicator on the
®
Bluetooth
button
LED flashes red 3 times.
To change communication channel
•
Push the channel button to select communication
channel 1, 2 or 3.
Note:
An audio message tells you which channel
you are in. Refer to the table below.
Audio message
CHANNEL 1
CHANNEL 2
CHANNEL 3
To speak to all communication channels
•
Push and hold the channel button to speak to all
communication channels at the same time.
Note:
You are connected to all communication
channels when you hear a beep sound. All channel
LED indicators are solid white to show that you are
connected to all channels.
•
Release the channel button to go back to the
previous channel.
To enable or disable the microphone
•
Push the mute button until you hear a beep sound.
To change audio streaming
•
Push and hold the volume up button for 0.5 seconds
to select the next audio streaming.
•
Push and hold the volume down button for 0.5
seconds to go back to the previous audio streaming.
To stop or start the audio streaming
•
Push the mode button to stop or start the audio
streaming.
To accept, end or dismiss a phone call
If your mobile device is connected to the product with
®
Bluetooth
wireless technology, a signal is heard in the
earmuffs when there is an incoming phone call.
•
Push the mode button to accept or end the phone
call.
•
Push the mode button for 1 second to dismiss an
incoming phone call.
Note:
A beep sound tells you when the phone call
is accepted or dismissed.
Channel LED indicator
Solid white on channel
1.
Solid white on channel
2.
Solid white on channel
3.
11
Publicidad
