Publicidad
•
Increase the separation between the equipment and
receiver.
•
Consult the dealer for help.
Marking on the product is found on the label on the right
earmuff.
Contains transmitter module IC: 12246A-
BM64S2
This device complies with Industry Canada license-
exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause
interference, and (2) this device must accept any
interference, including interference that may cause
undesired operation of the device.
Safety definitions
Warnings, cautions and notes are used to point out
specially important parts of the manual.
WARNING:
injury or death for the operator or bystanders
if the instructions in the manual are not
obeyed.
CAUTION:
damage to the product, other materials or
the adjacent area if the instructions in the
manual are not obeyed.
Note:
Used to give more information that is necessary
in a given situation.
General safety
WARNING:
instructions that follow before you use the
product.
•
Use and save these instructions.
•
For optimal fit and function, make sure that you have
selected the correct product for your use.
•
Do not change or remove parts on the product. Only
do changes that are given in this operator's manual.
•
The noise attenuation of the product will be severely
impaired if you do not follow the instructions in
this operator's manual. Ear-muffs, and in particular
cushions, may deteriorate with use and should be
examined at frequent intervals for cracking and
Maintenance on page 12 .
leakage. Refer to
•
This product may be adversely affected by certain
chemical substances. Further information should
be sought from the manufacturer. Keep away
from aggressive substances and clean the product
1957 - 002 - 09.10.2023
Used if there is a risk of
Used if there is a risk of
Read the warning
Under Industry Canada regulations, this radio
transmitter may only operate using an antenna of a
type and maximum (or lesser) gain approved for the
transmitter by Industry Canada. To reduce potential
radio interference to other users, the antenna type
and its gain must be so chosen that the equivalent
isotropically radiated power (e.i.r.p.) is not more than
that necessary for successful communication.
Registered trademarks
®
Bluetooth
The
trademarks owned by
of such marks by Husqvarna is under license.
Safety
regularly. Use a cloth with water and soap. Do not
wash or put fully into water.
•
All service and repair work must be done by an
approved service workshop. Only use Husqvarna
original spare parts.
•
Never use the ear-muffs longer than 10 years from
the manufacturing date stated on the packaging.
•
The functionality of the product may deteriorate with
battery consumption.
Safety instructions for operation
•
The wearer should ensure that the ear-muffs are
worn at all times in noisy environments.
•
Be more careful and listen for warning signals when
you use the product. The noise from warning signals
can be decreased when you use the product.
•
The audibility of warning signals at specific
workplace may be impaired while using the
entertainment facility.
•
Make sure that the product is not hit during
transportation and use.
•
Only use the product between temperatures -20°C
and +55°C/-4°F and +131°F. If you use the product
in other temperatures, this can cause damage to the
electronics, battery and mechanical parts.
•
Make sure that you know how to use the product
before use. Speak to your servicing dealer if there is
damage on the product. Do not open the casing!
•
The fitting of hygiene covers to the cushions, may
affect the acoustic performance of the ear-muffs.
Always use original accessories.
•
Do not push the earmuffs against the helmet shell. If
you do that, it can cause cracks around the side of
the helmet.
(Fig. 4)
•
Do not put the product in storage at temperatures
above +55°C/+131°F, for example on a dashboard.
Do not put the product in storage at temperatures
below -20°C/-4°F.
word mark and logos are registered
Bluetooth SIG, inc. and any use
7
Publicidad
