Muse M-18 RDC Manual De Instrucciones página 4

GB STEREO RADIO CD CASSETTE RECORDER
LOCATION OF CONTROLS
1
2
19
18
20
10
11
12
13
1. FUNCTION SWITCH [RADIO-TAPE (OFF)-CD]
2. VOLUME CONTROL
3. CASSETTE RECORDER KEYS
PAUSE: INTERRUPT RECORDING OR RESUME TAPE
OPERATION
STOP/EJ.: STOP THE TAPE /OPEN THE CASSETTE
COMPARTMENT
RWD: REWIND THE TAPE (TOWARD THE
BEGINNING)
F.FWD: ADVANCE THE TAPE (TOWARD THE END)
PLAY: START PLAYBACK
REC: START RECORDING
4. CD DOOR OPEN/CLOSE
5. CD COMPANTMENT
6. TUNING CONTROL
7. BAND SELECTOR(FM ST. / FM / AM)
POWER SUPPLY
This unit operates on AC (230 V 50 Hz) or DC (9V
Automatic standby mode
In a concern of saving energy, when playback has reached to the end and no control is operated on the device for a period of 10
minutes, the unit will automatically switch to Standby mode. In order to use the device again, slide the function switch [RADIO-TAPE
(OFF)-CD] to TAPE (OFF) position and then move to RADIO or CD position.
AC OPERATION
Connect the AC power cord from the unit to the mains. Make sure that the voltage is compatible with your device before turning it
on.
Disconnect the AC power cord from the mains when not in use.
BATTERY OPERATION
Open the battery compartment at the rear of the unit and insert 6 x "C" size batteries, observing the polarity diagram indicated
inside the compartment and close the compartment. To switch from AC power to battery power, disconnect the AC power cord.
Battery Replacement
Batteries should be replaced when the volume decreases or the sound distorts .
Notes on batteries
• Do not mix different types of batteries or old batteries with new ones.
• Never recharge the batteries, apply heat to them or take them apart.
• Battery shall not be exposed to excessive heat such as sunshine, fire or the like.
• Attention should be drawn to the environmental aspects of battery disposal.
RKD-3682 IB MUSE 001 REV0.indd 4
9
8
7
6
5
4
3
17
16
15
14
21 22
8. HANDLE
9. TELESCOPIC ANTENNA
10. STOP BUTTON
11. SKIP- BUTTON(CD BACK BUTTON)
12. SKIP+ BUTTON(CD NEXT BUTTON)
13. CASSETTE COMPARTMENT
14. SPEAKER
15. REPEAT BUTTON
16. PROGRAM BUTTON
17. PLAY/PAUSE BUTTON
18. FM STEREO INDICATOR
19. LED DISPLAY
20. POWER INDICATOR LIGHT
21. BATTERIES COMPARTMENT
22. AC AC INPUT SOCKET
) 6x 1.5V Type UM-2 / R 14 / '' C'' (Batteries not included).
EN - 1
Before throwing any batteries away, consult your distributor who may be able to take them back for specific recycling.
NOTE: In order to avoid leakage, always remove the batteries when unit will not be used for a long period of time.
LISTENING TO THE RADIO
1. Slide the function switch [RADIO-TAPE (OFF)-CD] to RADIO position.
2. Select FM ST./ FM / AM by switching the band selector.
3. Select your radio station by the TURNING control and adjust the volume control to your desired sound level.
4. To turn off the unit, Slide the function switch [RADIO-TAPE (OFF)-CD] to TAPE (OFF) position.
Note:
1. FM stereo LED indicator lights if receive FM stereo broadcast and the BAND switch set on "FM ST".
2. When too much noise is heard during FM STEREO reception, set BAND switch to FM.
To enhance radio reception ability:
FM: Extend the FM antenna.
AM (MW): Rotate the unit horizontally for optimum reception.
LISTENING TO CD DISC
1. Open the CD door.
2. Insert the disc with the label facing up and then close the compartment.
3. Slide the function switch [RADIO-TAPE (OFF)-CD] to CD position. Display shows "
4. The total number of tracks is displayed, press PLAY/PAUSE
5. Adjust the VOLUME control to the desired level.
NOTE: During the playback, use the PLAY/PAUSE
to suspend momentarily the playing track. Press PLAY/PAUSE
again to resume playing.
button and then slide the function switch [RADIO-TAPE (OFF)-CD] to TAPE (OFF)
6. To stop listening to the disc, press STOP
position
OTHER CD PLAYER FUNCTIONS
SKIP/ SEARCH DOWN & SKIP/SEARCH UP
1. Press SKIP+ to skip forward to the next track or repeatedly to skip several tracks.
2. Press SKIP- return to the beginning of the track, or press repeatedly to skip backwards several tracks.
3. Press and hold SKIP+ or SKIP- to search quickly within a track.
REPEAT PLAYBACK
Repeatedly press REPEAT button to select one of the following playback modes.
• Repeat one (The repeat indicator is flashing)
• Repeat All (The repeat indicator remains on)
• Normal playback
PROGRAM:
1. Press STOP .
2. Press PROGRAM, " "blinks.
3. Select the desired track with SKIP+ or SKIP- then press PROGRAM to save the program in memory.
4. Repeat step 2-3 until the end of your programming.
to start playback. During CD program playback, LED indicator shows:
5. Press PLAY/PAUSE
6. This PROGRAM function is automatically canceled when opening the CD door OR shutdown of the unit OR press STOP
twice.
Note:
CD up to 20 programs
NOTE ON COMPACT DISCS
• Do not use irregular shape CDs (example: heart-shaped, octagonal ones). It may result in malfunctions.
• Do not place more than one disc in the disc compartment.
• Do not try to open the disc compartment during playing.
• Do not touch the lens. Doing so may cause malfunction.
• CD-Rs or CD-RWs playback capability at this player may vary depending on quality of media, CD-Burner, speed of burning and
application software.
".
to start playback.
EN - 2
2015/5/5 18:19:53
once
button