Publicidad
Idiomas disponibles
Idiomas disponibles
Drive Control
Recoil Starter
Blade Control
The blade control is attached to the upper handle of the mower. Depress and
squeeze it against the drive control to operate the unit. Release it to stop engine
and blade.
This blade control is a safety device. Never attempt to bypass its operation.
Drive Controls
The drive controls are located on top of the upper handle and are used to engage
the drive. Squeeze the right, left, or both right and left controls against the upper
handle to engage the drive; release it/them to slow down or stop mower from
propelling.
Speed Control
The speed control is located on the variable speed control housing on the upper
handle. This control is used to select the forward speed of the mower. See Figure 13
inset.
IMPORTANT: Move the speed control only when the engine is running. Changing
the speed control setting with the engine off can damage the mower.
Recoil Starter
The recoil starter is attached to the right upper handle. Stand behind the unit and
pull the recoil starter rope to start the unit.
Craftsman Lawn Mowers conform to the safety standard of the American National Standards Institute (ANSI).
Speed
Drive Control
Control
Trail Shield
(Not Shown)
Side Discharge
Chute
WARNING
Meets ANSI Safety Standards
OPERATION
Blade Control
Figure 13
Trail Shield
The trail shield is attached to the rear of the mower and is there to protect the
operator from flying debris. Do not use the mower unless the shield is fully
functional and in place.
Cutting Height Adjustment Lever
The cutting height adjustment lever is located above the left rear wheel. To adjust
the cutting height, refer to page 11 in the Assembly Section.
Deck Wash
Your mower's deck is equipped with a water port on its surface as part of its deck
wash system. Use the deck wash to rinse grass clippings from the deck's underside.
Side Discharge Cover
Your mower is shipped as a mulcher. To discharge the grass clippings to the side
instead, follow the instructions on page 10 in the Assembly section to attach the
side discharge cover.
Keep hands and feet away from the chute area on cutting deck. Refer to
warning label on the unit.
12
Speed
Control
Cutting Height
Adjustment Lever
Deck Wash
WARNING
Publicidad
