Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY AND GENERAL INFORMATION
Save these instructions. For your safety, read and
understand the information contained within. The
owner and operator of this equipment shall have an
understanding of this product and safe operating
p
o r
c
e
d
u
e r
s
b
e
o f
e r
t a
Instructions and safety information shall be conveyed
in the operator's native language before use of this
product is authorized. If any doubt exists as to the safe
and proper use of this product as outlined in this factory
authorized manual, remove from service immediately.
Inspect before each use. Do not use if broken, bent,
cracked, or damaged parts (including labels) are noted.
If the jack stand has been or suspected to have been
subjected to a shock load (a load dropped suddenly
and unexpectedly upon it), discontinue use until
checked out by an authorized factory service center.
It is recommended that an annual inspection be
Model
Capacity (per pair)
PL3200
PL3300
PL3600
PREPARATION
1. Before using this product, read the owner's manual
and familiarize yourself thoroughly with the product
and the hazards associated with its improper use.
2. Inspect stands before each use. Do not use if bent,
broken or cracked components are noted. Ensure
that all parts move freely.
3. Verify the product and your application are
compatible. If in doubt, contact Pro-Lift Customer
Support @ (888)332-6419.
4. Install ratchet bar into frame. Ratchet portion of bar
must be aligned with ratchet pawl (stopper).
5. Move the ratchet bar to its lowest position by raising
the locking handle, releasing the ratchet pawl, and
guiding the bar downward.
6. Ratchet bar/collar lock is accomplished by bending
the press tab (Fig.1) inward using a suitable
hammer and punch. This will prevent inadvertent
loss of the ratchet bar.
7. Always check the vehicle owners or service manual
for location of proper lift and support points.
e t
m
t p
n i
g
o t
u
s
e
h t
s i
2 Ton
3 Ton
6 Ton
damaged parts, decals, warning/safety labels or signs
be replaced with factory authorized replacement parts
only. Any jack stand that appears to be damaged in any
way, is worn or operates abnormally shall be removed
from service immediately.
p
o r
d
u
c
. t
PRODUCT DESCRIPTION
Pro-Lift Jack Stands are designed to safely support,
level, rated capacity, partial vehicle loads consisting of
one end of a vehicle. Each comes with a ratchet/collar
lock tab which prevents inadvertent loss of ratchet bar.
Use as an identical pair to support one end of a vehicle
only. The jack stand is equipped with a mobility pin that
inserts into the mobility pin hole.
SPECIFICATIONS
Base Size
7-1/4" x 6-3/4"
7-5/8" x 6-7/8"
10-1/2" x 9"
Mobility
Pin Hole
Press Tab
Locking Handle
Figure 1 - Typical Jack Stand Nomenclature
2
Min. Height
10-7/8"
11-1/4"
15"
Saddle
Ratchet Bar
Ratchet Pawl
Max. Height
16-7/8"
16-3/4"
23-1/4"
Mobility Pin
Base Frame
Publicidad
