Premier TEL-4736IL Manual De Instrucciones página 31

Notice : You can only cancel subscription of another handset, not the handset you are using to do the
remove procedure.
5.2 Setting the Dialing Mode
There are two types of dialing mode: DTMF (Tone) and Pulse dialing.
(1) Press the <MENU> button.
(2) Use the <▲> or <▼> button to scroll to [BS SETTINGS] and press <OK>.
(3) Use the <▲> or <▼> button to scroll to [DIAL MODE] and press <OK>.
(4) Use the <▲> or <▼> button to select [TONE] or [PULSE] and press <OK>.
5.3 Flash Button (Recall)
When you press the <R> button during conversation, also called flash or recall, the unit generates a line
interruption. It gives you the possibility to use the special services of your telephone provider and/or to
transfer calls when you have a telephone exchange.
Setting the Flash Time:
(1) Press the <MENU> button.
(2) Use the <▲> or <▼> button to scroll to [BS SETTINGS] and press <OK>.
(3) Use the <▲> or <▼> button to scroll to [FLASH TIME] and press <OK>.
(4) Use the <▲> or <▼> button to select three values of flash time durations. The unit of flash time
value is msec.
(5) Press <OK> to confirm.
5.4 Changing the PIN Code (System PIN Code)
Certain functions are only available if you know the PIN code of the base.
The PIN code has 4 digits. The default PIN code setting is '0000'. If you would like to change the PIN
code and set your own secret code, do the following:
(1) Press <MENU> button.
(2) Use the <UP> or <DOWN> button to scroll to [BS SETTINGS] and press <OK>.
(3) Use the <UP> or <DOWN> button to scroll to [MODIFY PIN] and press <OK>.
(4) Enter the old PIN and press <OK>.
(5) Enter the new PIN and press <OK>.
(6) Press the new PIN again and press <OK>. If it is successful, it gives a long beep.
NOTE:
If the wrong PIN code is entered, it will give error beep and ask for input the PIN numbers again.
5.5 Set Zero Emission
For DECT system, the base unit should always keep sending a beacon signal to handset unit to make
sure its existence. So that it can guarantee base unit can immediately connect to handset unit whenever
ring come. This beacon signal is a 1V/m 1.8GHz RF power with 0.5ms for every 10ms. Although the
radiation time slot is very small, it still has risk to hazard human health due to 24hours a day in high
frequency environment. Right now, DSPG creates a NEMo (No Emission Mode) feature to make real no
P-8