IPC 121195 Manual De Instrucciones página 23

USING THE HIGH
PRESSURE WASHER
CONTROL PANEL
A - Main switch.
B - Manual button to fill the
hydraulic circuit with anti-
freeze.
C - Start button.
D - Stop button.
E - Power on button.
F - Pressure gauge.
STARTING THE HIGH PRESSURE WASHER
1) Open the water supply tap (fig. 2A).
2) Connect the high pressure washer to the mains electricity
supply by an omnipolar switch and by plugging it into the
mains socket.
3) Turn the high pressure washer on by turning the main switch
to the "I" position (fig. 4A).
4) Press the start button (C (Fig. 4).
! Important
The water jet generates recoil on the lance. Stand in a stable
position and hold the lance handgrip firmly.
5) Press the handgrip trigger and start washing.
Important
!
In high pressure washers with the Total Stop system, the mo-
tor starts and stops when the trigger on the lance handgrip is
pressed or released.
!
Danger
Do not block the handgrip trigger in the delivery position.
Important
!
Always check the tightness of the water supply hose and high
pressure hose couplings.
IMPORTANT INFORMA-
TION!
To eliminate impurities or air
bubbles from the hydraulic
circuit, start up the high
pressure washer for the first
time without the lance and
allow the water to flow out
for a few seconds.
Impurities could block the
nozzle and prevent it from
operating (Fig. 5).
English
E
C
A
D
B
F
FIG. 4
FIG. 5
- 20 -
USING THE ACCESSORIES.
The high pressure washer has a nozzle with a flat 15° angle jet
for cleaning large surfaces.
!
Important
Aim the jet from a certain distance to avoid damage caused by
the high pressure.
ROTARY HEAD (optional accessory)
The high pressure washer can be fitted with a head with rotary
nozzle to clean the most stubborn dirt.
!
Danger:
Aim the jet from a certain distance to avoid damage caused by
the high pressure.
Do not aim the jet at people, animals or electrical sockets.
STOPPING THE HIGH PRESSURE WASHER
1) Stop the high pressure washer by pressing the stop button
D.
2) Turn the main switch to the "0" position (fig. 4A).
!
Important
3) Release the pressure in the H.P. circuit by pressing the
gun trigger.
4) Disconnect the high pressure washer from the mains electri-
city supply by the omnipolar switch and unplugging it from the
mains socket.
5) Close the water supply tap (fig. 2A).
!
Important
When you leave the high pressure washer unattended even
briefly, turn it off by the omnipolar switch and unplugging it from
the mains socket.
!
Important
High pressure washers with Total Stop device are considered
off when the omnipolar switch is in the "0" position and when
unplugged from the mains socket.
!
Important
When the high pressure
washer is not in use, close
the safety device on the han-
dgrip (fig. 6).
!
Important
Operating the high pressure
washer without water se-
riously damages the pump
gaskets.
FIG. 6