Actelser ACT1222 Manual De Instalación página 6

6
ACTELSER Switch ACT1222
Connect the Smart Switch to your network
Connect the switch to your network. Any port can be used for that
n
Connect all computers to the switch or to devices connected to the switch
n
Connect the switch with the delivered power supply to the mains power
n
The switch will boot with default settings and automatically creates the link to connected devices
n
Configure the Smart Switch
In Default Settings the Switch has a fixed IP Address:
Change the IP Address of the connected Computer to an fixed Address in the same
n
network part 192.168.0.xxx (e.g. xxx = 100)
Enter Default IP address of the switch in any Webbrowser on your computer.
n
192.168.0.10
If there is a DHCP-Server connected to the switch, it receives a DHCP-Address automatically.
n
In this case, use the IP-Address configured by the DHCP-Server to access the switch.
After restarting the switch without DHCP-Server connected, it will be reachable with the default address again.
Login with the default login data on the configuration interface of the switch:
n
USER: admin
Password: admin
Configure the switch for your network.
n
For security reasons, default login data should be changed to secure login data only known to permitted persons!
More information for the configuration via web interface can be found in our manual under:
n
www.actelser.com