Actelser ACT1222 Manual De Instalación página 7

Troubleshooting Tips
Here are some tips for correcting problems:
Check if all cables are connected properly.
n
For every activated device connected to any port of the switch, the corresponding switch LAN port status LED is lit.
For the POF Ports make sure, that all fibres are cleanly cut and fully (20mm with open clamp) pushed inside
the clamp. Check also the connections at connected devices
Make sure the network settings of the computer are correct.
n
In most cases, computers are configured to obtain an IP address through DHCP. If the network uses static IP addresses, be
sure that the switch and computer are configured with valid IP addresses. To connect to the web interface,
IP address oft he computer hast o be in the same subnet as the switch (e.g. switch: 192.168.0.xxx, computer: 192.168.0.xxx)
Support
Thank you for selecting ACTELSER products.
Support can be reached under service contact data from:
www.actelser.com
Please locate serial number on the product and use it for registration when contacting our support.
You have to register your product before you can use our telephone support.
We recommend using only official ACTELSER support resources.
ACTELSER Switch ACT1222
7