Pur Line NTW-09 Manual De Instrucciones página 18

EN
OPERATION
A. Before use
1. Connect the leakage breaker plug at the wall
socket.
2. Press "RESET" button to power on the plug.
3. Press "T" to check the correct operation of the
transformer.
4. If the breaker plug is no problem, then press
"RESET" button again to start operating on
control board.
B. On/Off
1. Press and hold the button 1second to turn
on the heater, and the initial temperature is set
at 55ºC
2. Press and hold the button 1second again,
the heater would be turned off.
C. Timer
1. When the heater is turned on, user can set off
time from 1hour to 24hour by press the
button from 1hour to 24hour, and the displayer
would show 01 to 24.
2. The time setting would be confirmed after
5seconds without operating.
D. Temperature setting
1. When the heater is turned on, user can set
temperature by press the button from 45
to 70ºC and the displayer would show numbers
accordingly.
2. The temperature setting would be confirmed
after 5seconds without operating.
E. Self-detect
When there is any circuit abnormality, IC would automatically detect
it and show E1, and then the heater would be shut down to protect.
16